大功率LED散热器自然对流方向效应实验

单龙; 胡学功; 王际辉; 田红

doi:10.3788/fgxb20194006.0781

您当前的位置：

首页 >

文章列表页 >

大功率LED散热器自然对流方向效应实验

器件制备及器件物理 | 更新时间：2020-08-12

- 大功率LED散热器自然对流方向效应实验
- Orientation Effects Experiment on Natural Convection of High Power LED Heat Sink
- 发光学报 2019年40卷第6期页码：781-787
- 作者机构：
  
  中国科学院工程热物理研究所, 北京 100190
- 作者简介：
- 基金信息：
  
  国家重点研发计划（2017YFB0403200）资助项目()
- DOI：10.3788/fgxb20194006.0781
  中图分类号： TK124
- 纸质出版日期：2019-6-5，
  
  网络出版日期：2018-10-15，
  
  收稿日期：2018-6-27，
  
  修回日期：2018-10-20，
扫描看全文
单龙, 胡学功, 王际辉等. 大功率LED散热器自然对流方向效应实验[J]. 发光学报, 2019,40(6): 781-787

SHAN Long, HU Xue-gong, WANG Ji-hui etc. Orientation Effects Experiment on Natural Convection of High Power LED Heat Sink[J]. Chinese Journal of Luminescence, 2019,40(6): 781-787
单龙, 胡学功, 王际辉等. 大功率LED散热器自然对流方向效应实验[J]. 发光学报, 2019,40(6): 781-787 DOI： 10.3788/fgxb20194006.0781.

SHAN Long, HU Xue-gong, WANG Ji-hui etc. Orientation Effects Experiment on Natural Convection of High Power LED Heat Sink[J]. Chinese Journal of Luminescence, 2019,40(6): 781-787 DOI： 10.3788/fgxb20194006.0781.

摘要

为了研究采用微槽群复合相变换热技术的大功率太阳花散热器多角度投光的方向效应及综合散热性能，实验研究了散热器高度、功率以及采用微槽群复合相变换热技术后的过余温度、平均对流换热系数随出光倾角的变化规律，并获得了出光倾角的

与

关联式。研究结果表明:出光倾角小于90时，微槽群散热器热源过余温度大幅低于型材散热器，在高度为90 mm，出光倾角为30，输入功率为80，100，120，200 W时热源温度分别降低了11.6，13.3，18.9，26.7 K，呈现出功率越大降幅越大的趋势；出光倾角大于90时，微槽群散热器热源过余温度略高于型材散热器，原因是微槽群散热器内部的真空环境影响散热器的均温性；输入功率越高，方向效应越明显；散热器高度越低，平均对流换热系数越大，对比高度60 mm与高度90 mm，在出光倾角为0时，功率为80，100，120 W时分别提高了27.5%、23.8%和24.2%。因此，设计LED灯具散热器时应综合考虑散热器的方向效应。

Abstract

In order to study the orientation effects and the comprehensive heat dissipation performance of the high power radiator heat sink with the phase-change heat transfer in capillary microgrooves heat sinks

the experiment studies the variation of height

power and whether using the phase-change heat transfer in capillary microgrooves heat sinks on excess temperature and the mean convection heat transfer coefficient with the installation angles. And the correlations between the

and

are obtained. The results show that when the installation angle is less than 90 degrees

the excess temperature of heat source for microgrooves heat sinks is much lower than that of the section heat sink. When the installation angle is 30 degrees

the height is 90 mm

the input power is 80

100

120

200 W

the heat source excess temperature 11.6

13.3

18.9

26.7 K are reduced respectively

and the greater the input power

the greater the reduction. When the installation angle is greater than 90 degrees

the excess temperature of the microgrooves heat sinks is slightly higher than that of the section heat sink

and the reason is that the vacuum environment inside the microgrooves heat sinks affects the temperature uniformity

the higher the input power

the more obvious the orientation effects. The lower the height is

the greater the mean convection heat transfer coefficient is. When the installation angle is 0

the input power is 80

100

120 W

compared with height 60 mm and height 90 mm

the mean convection heat transfer coefficient increased by 27.5%

23.8% and 24.2%. Therefore

the orientation effects of the radiator should be considered when designing the radiator for LED lamps.

关键词

大功率LED方向效应微槽群自然对流太阳花散热器

Keywords

high power LEDorientation effectsmicrogroovesnatural convectionradiator

references

CHRISTENSEN A, GRAHAM S. Thermal effects in packaging high power light emitting diode arrays[J]. Appl. Therm. Eng., 2009, 29(2-3):364-371.

LIU J, TAM W S, WONG H, et al.. Temperature-dependent light-emitting characteristics of InGaN/GaN diodes[J]. Microelectron.Reliab., 2009, 49(1):38-41.

SERTKAYA A A, BILIR ?, KARGICI S. Experimental investigation of the effects of orientation angle on heat transfer performance of pin-finned surfaces in natural convection[J]. Energy, 2011, 36(3):1513-1517.

SHEN Q, SUN D M, XU Y, et al.. Orientation effects on natural convection heat dissipation of rectangular fin heat sinks mounted on LEDs[J]. Int. J. Heat Mass Transfer, 2014, 75:462-469.

WANG J C. Thermal module design and analysis of a 230 W LED illumination lamp under three incline angles[J]. Microelectron. J., 2014, 45(4):416-423.

MENG X R, ZHU J, WEI X L, et al.. Natural convection heat transfer of a straight-fin heat sink[J]. Int. J. Heat Mass Transfer, 2018, 123:561-568.

JANG D, YOOK S J, LEE K S. Optimum design of a radial heat sink with a fin-height profile for high-power LED lighting applications[J]. Appl. Energy, 2014, 116:260-268.

张建新, 杨庆新, 牛萍娟, 等. LED板状肋片散热器性能的方向效应[J].发光学报, 2015, 36(7):846-853. ZHANG J X, YANG Q X, NIU P L, et al.. Orientation effects on heat dissipation performance of plate-fin heat sink for LED application[J]. Chin. J. Lumin., 2015, 36(7):846-853. (in Chinese)

EFFENDI N S, KIM K J. Orientation effects on natural convective performance of hybrid fin heat sinks[J]. Appl. Therm. Eng., 2017, 123:527-536.

JANG D, PARK S J, YOOK S J, et al.. The orientation effect for cylindrical heat sinks with application to LED light bulbs[J]. Int. J. Heat Mass Transfer, 2014, 71:496-502.

LI B, BYON C. Investigation of natural convection heat transfer around a radial heat sink with a concentric ring[J]. Int. J. Heat Mass Transfer, 2015, 89:159-164.

LI B, JEON S, BYON C. Investigation of natural convection heat transfer around a radial heat sink with a perforated ring[J]. Int. J. Heat Mass Transfer, 2016, 97:705-711.

侯绿, 陈华, 周兴林. 基于导热塑料的新型LED灯散热器设计与优化[J].发光学报, 2016, 37(9):1103-1108. HOU L, CHEN H, ZHOU X L. Design and optimization of a new type LED lamp radiator based on thermal conductive plastics[J]. Chin. J. Lumin., 2016, 37(9):1103-1108. (in Chinese)

张建新, 韩变华, 杨庆新, 等. 热电制冷LED自然对流散热的设计与优化[J].发光学报, 2018, 39(4):523-533. ZHANG J X, HAN B H, YANG Q X, et al.. Thermal design and optimization of LED integrated with thermoelectric cooler in natural convection[J]. Chin. J. Lumin., 2018, 39(4):523-533. (in Chinese)

何凡, 陈清华, 刘娟芳, 等.集成芯片LED场地照明灯新型叠片散热器热分析[J].发光学报, 2014, 35(6):742-747. HE F, CHEN Q H, LIU J F, et al.. Thermal analysis of high mast integrated LED lamp with new heatsink structure of laminated pure aluminum plate[J]. Chin. J. Lumin., 2014, 35(6):742-747. (in Chinese)

YU D, HU X G, GUO C H, et al..Visualization of microbubble dynamic behaviors in open rectangular microgrooves heat sinks under saturated boiling condition[J]. Appl. Therm. Eng., 2015, 80:424-435.

GUO C H, HU X G, CAO W, et al.. Effect of mechanical vibration on flow and heat transfer characteristics in rectangular microgrooves[J]. Appl. Therm. Eng., 2013, 52(2):385-393.

NIE X L, HU X G, TANG D W. Modeling study on axial wetting length of meniscus in vertical rectangular microgrooves[J]. Appl. Therm. Eng., 2013, 52(2):615-622.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

热电制冷LED自然对流散热的设计与优化

插指型SiO₂电流阻挡层对大功率LED外量子效率的影响

纳米银焊膏封装大功率COB LED模块的性能研究

基于电晕放电的大功率LED散热研究

LED板状肋片散热器性能的方向效应