基于荧光玻璃的高效LED白光技术

黄波; 童玉珍; 李成明; 胡西多; 何苗; 郑树文; 李述体

doi:10.3788/fgxb20163706.0637

您当前的位置：

首页 >

文章列表页 >

基于荧光玻璃的高效LED白光技术

材料合成及性能 | 更新时间：2020-08-12

- 基于荧光玻璃的高效LED白光技术
- High-efficiency Technology of LED White Light Based on Phosphor Glass
- 发光学报 2016年37卷第6期页码：637-643
- 作者机构：
  
  1. 东莞理工学院电子工程学院,广东东莞,523000
  2. 华南师范大学光电子材料与技术研究所, 广东省微纳光子功能材料与器件重点实验室,广东广州,510631
  3. 北京大学东莞光电研究院,广东东莞,523000
  4. 华南师范大学广东省光电功能材料与器件工程技术研究中心,广东广州,510631
- 作者简介：
- 基金信息：
  
  "973"国家重点基础研究发展计划(2011CB013101);广东省省级科技项目(2013B090500004);东莞市产学研合作项目(2014509130207);863"国家技术研究发展计划(2013AA03A110);高等学校博士学科点专项科研基金(20134407110008);广东省科技厅省部产学研合作专项资金(2012B09100069)资助项目
- DOI：10.3788/fgxb20163706.0637
  中图分类号： TP394.1;O482.31
- 纸质出版日期：2016-06-05，
  
  收稿日期：2016-01-25，
  
  修回日期：2016-03-02，
- 稿件说明：
扫描看全文
黄波, 童玉珍, 李成明等. 基于荧光玻璃的高效LED白光技术[J]. 发光学报, 2016,37(6): 637-643

HUANG Bo, TONG Yu-zhen, LI Cheng-ming etc. High-efficiency Technology of LED White Light Based on Phosphor Glass[J]. Chinese Journal of Luminescence, 2016,37(6): 637-643
黄波, 童玉珍, 李成明等. 基于荧光玻璃的高效LED白光技术[J]. 发光学报, 2016,37(6): 637-643 DOI： 10.3788/fgxb20163706.0637.

HUANG Bo, TONG Yu-zhen, LI Cheng-ming etc. High-efficiency Technology of LED White Light Based on Phosphor Glass[J]. Chinese Journal of Luminescence, 2016,37(6): 637-643 DOI： 10.3788/fgxb20163706.0637.

摘要

采用高温熔融法制备了一定质量比例的SiO

-YAG:Ce

片状荧光玻璃

厚度为0.2mm

分析其XRD物相、光学和SEM微观结构、PL光谱。结果表明:荧光玻璃保留了晶相

荧光粉颗粒在玻璃基质中均匀分布

荧光玻璃和荧光粉的激发响应关系一致。在465nm蓝光激发下

发射波长均在535nm附近

表明荧光玻璃除含有玻璃相

还有荧光粉的物质结构特性。将不同波长蓝光芯片与不同荧光粉含量的荧光玻璃进行封装测试

结果表明:器件的流明效率可达到234.81lm/W;色温和显色指数均随荧光粉含量增加而单调下降

呈现高色温和低显色指数;荧光粉质量分数从6%增加至15%时

不同波长激发下的色坐标

与

呈现大致相同的线性变化率。采用450nm激光激发荧光玻璃

测试样品温度变化发现温升较缓

温降迅速

耐热性能优越。实验结果表明

将荧光玻璃用于LED白光照明封装

能实现流明效率和耐热性能的大幅提升

形成良好的白光输出。

Abstract

SiO

glass powder and a certain mass proportion of YAG:Ce

phosphor powder were taken to prepare SiO

-YAG:Ce

PG with melting method

and then the samples were prepared into 0.2 mm thickness for XRD phase

structure of optical micrographs and SEM

and PL spectrum test analysis. The results show that the phase of phosphor is retained in PG and the phosphor particles are uniformly distributed in the glass matrix. Consistent excitation and response relationship of PG and phosphor is observed that the excitation wavelength is about 465 nm and the emission wavelength is about 535 nm. The structure characteristics of phosphor are retained in PG except the glass phase. The blue LED chips with different wavelengths were packaged with the PG samples. The test results indicate that the luminous efficiency can reach at 234.81 lm/W

and the color temperature and CRI monotonically decrease with the increasing of phosphor content in PG

all of which are at a high level. Under different wavelength excitation

and

in the chromaticity coordinates present roughly same linear rate of change when the mass fraction of phosphor in PG increases from 6% to 15%. In addition

the temperature of PG rose relative slowly and dropped sharply when the PG sample was excited by 450 nm laser

indicating a nice property of heat resistance. The experiment results show that the superior optical properties and heat resistance can be obtained by PG packaged LED

and excellent white light output can be formed.

关键词

SiO2-YAG:Ce3+荧光玻璃封装光学特性耐热性能

Keywords

SiO2-YAG:Ce3+phosphor glass(PG)packageoptical propertiesheat resistance

references

NAKAMURA S. InGaN multiquantum-well-structure laser diodes with GaN-AlGaN modulation-doped strained-layer superlattices [J]. IEEE J. Sel. Top. Quant. Electron., 1998, 4(3):483-489.

FUJITA S, SAKAMOTO A, TANABE S. Luminescence characteristics of YAG glass-ceramic phosphor for white LED [J]. IEEE J. Sel. Top. Quant. Electron., 2008, 14(5):1387-1391.

FUJITA S, TANABE S. Fabrication, microstructure and optical properties of Er3+:YAG glass-ceramics [J]. Opt. Mater., 2010, 32(9):886-890.

WANG J, TSAI C C, CHENG W C, et al.. High thermal stability of phosphor-converted white light-emitting diodes employing Ce:YAG-doped glass [J]. IEEE J. Sel. Top. Quant. Electron., 2011, 17(3):741-746.

YANG L, XIE A, XIE D, et al.. A new method of robust phosphor glass fabrication and performances for LEDs [C]. Proceedings of The 2015 16th International Conference on Electronic Packaging Technology (ICEPT), Changsha, China, 2015:1258-1262.

NISHIURA S, TANABE S. Preparation and luminescence properties of glass ceramics precipitated with M2MgSi2O7:Eu2+ (M=Sr, Ca) phosphor for white light source[J]. IEEE J. Sel. Top. Quant. Electron., 2009, 15(4):1177-1180.

CHEN D Q, XIANG W D, LIANG X J, et al.. Advances in transparent glass-ceramic phosphors for white light-emitting diodesA review [J]. J. Eur. Ceram. Soc., 2015, 35(3):859-869.

周青超,柏泽龙,鲁路,等. 白光LED远程荧光粉技术研究进展与展望 [J]. 中国光学, 2015, 8(3):313-328. ZHOU Q C, BAI Z L, LU L, et al.. Remote phosphor technology for white LED applications: advances and prospects [J]. Chin. Opt., 2015, 8(3):313-328. (in Chinese)

PHELAN R J. InSb-GaAsP infrared to visible light converter [J]. Proc. IEEE, 1967, 55(8):1501-1502.

NAKAMURA S. InGaN-based blue laser diodes [J]. IEEE J. Sel. Top. Quant. Electron., 1997, 3(3):712-718.

WIERER J J. The potential of Ⅲ-nitride laser diodes as a future solid-state lighting source [C]. Proceedings of The 2013 IEEE Photonics Conference (IPC), Bellevue, USA, 2013:173.

WIERER J J JR, TSAO J Y, SIZOV D S. Comparison between blue lasers and light-emitting diodes for future solid-state lighting [J]. Laser Photon. Rev., 2013, 7(6):963-993.

CHEN K J, LIN B C, CHEN H C, et al.. Effect of the thermal characteristics of phosphor for the conformal and remote structures in white light-emitting diodes [J]. IEEE Photon. J., 2013, 5(5):8200508.

YAN B, YOU J P, TRAN N T, et al.. Influence of phosphor configuration on thermal performance of high power white LED array [C]. Proceedings of The 2013 IEEE International Symposium on Advanced Packaging Materials (APM), Irvine, USA, 2013:274-289.

ZHU Y M, HU J Y, HU R, et al.. Thermal model of phosphor self-heating in phosphor-converted light-emitting diodes [C]. Proceedings of The 2015 16th International Conference on Electronic Packaging Technology (ICEPT), Changsha, China, 2015:1090-1093.

朱学绘,范广涵,何安和,等. SiO2-YAG:Ce3+玻璃荧光体的制备及其白光LED的封装 [J]. 华南师范大学学报(自然科学版), 2010(1):62-66. ZHU X H, FAN G H, HE A H, et al.. SiO2-YAG:Ce3+ glass phosphor prepared for white led packaging [J]. J. South China Normal Univ. (Nat. Sci. Ed.), 2010(1):62-66. (in Chinese)

LIN I C, NAVROTSK Y A, WEBER J K R, et al.. Thermodynamics of glass formation and metastable solidification of molten Y3Al5O12 [J]. J. Non-Cryst. Solids, 1999, 243(2-3):273-276.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

退火温度对旋涂法制备SnO₂薄膜性能的影响

大功率远程荧光粉型白光LED散热封装设计

射频磁控溅射法制备SnS₂薄膜结构和光学特性的研究

射频磁控溅射法制备SnS薄膜及其结构和光学特性

Al-N共掺杂ZnO电子结构和光学性质