浏览全部资源
扫码关注微信
1. 天津工业大学 天津市电工电能新技术重点实验室 天津,300387
2. 天津工业大学 大功率半导体照明应用系统教育部工程研究中心 天津,300387
3. 天津工业大学 中空纤维膜材料与膜过程省部共建国家重点实验室 天津,300387
纸质出版日期:2015-7-3,
收稿日期:2015-3-7,
修回日期:2015-5-11,
扫 描 看 全 文
张建新, 杨庆新, 牛萍娟等. LED板状肋片散热器性能的方向效应[J]. 发光学报, 2015,36(7): 846-853
ZHANG Jian-xin, YANG Qing-xin, NIU Ping-juan etc. Orientation Effects on Heat Dissipation Performance of Plate-fin Heat Sink for LED Application[J]. Chinese Journal of Luminescence, 2015,36(7): 846-853
张建新, 杨庆新, 牛萍娟等. LED板状肋片散热器性能的方向效应[J]. 发光学报, 2015,36(7): 846-853 DOI: 10.3788/fgxb20153607.0846.
ZHANG Jian-xin, YANG Qing-xin, NIU Ping-juan etc. Orientation Effects on Heat Dissipation Performance of Plate-fin Heat Sink for LED Application[J]. Chinese Journal of Luminescence, 2015,36(7): 846-853 DOI: 10.3788/fgxb20153607.0846.
为考察装配板状肋片散热器的多角度照射型LED灯的自然对流散热性能的方向效应
以一款LED投光灯的关键散热结构为研究对象
采用实验测量法验证数值模拟的计算精度
并将数值模拟的温度和流体数据用于分析3种驱动电流和7个出光倾角下最大温升和温度均匀性的散热机制。结果表明:不同倾角下的散热器肋间风道内的流速分布的较大差异
是导致最大温升和温度均匀性变化的根本原因;最高温度点的上、下游流速的差值可用于定量解释温度均匀性的变化规律。不同倾角下肋片间距对最大温升的影响趋势表明:最佳间距附近的散热器性能对倾角的敏感度最高
散热能力的方向效应不容忽视。
The plate-fin heat sink is widely used in LED lamp for application of multi-angle illumination. According to the key structures of a LED projection lamp
the orientation effects on heat dissipation performance of plate-fin heat sink with natural convection cooling were researched under 3 driving currents and 7 inclination angles between illumination direction and gravity direction. Based on the validity and accuracy of numerical simulation verified by experimental results
the thermal mechanisms with respect to maximum excess temperature and temperature uniformity were investigated through analyzing temperature and flow data derived from numerical simulation. The obvious differences of air velocity distribution in the flow channel of fins are found among inclination angles
these differences are the main reason of sensitive orientation effect about maximum excess temperature and temperature uniformity. In addition
air velocity difference between upstream and downstream around the measuring point with maximum temperature can be used to quantitatively interpret the variation trend of temperature uniformity in different inclination angles. Furthermore
the effects of inclination angle and fin spacing on the maximum excess temperature were analyzed. The results show that the heat dissipation performance of plate-fin heat sink with optimal fin spacing has high orientation sensitivity
so the study of orientation effects on the air flow and heat transfer of plate-fin heat sinks is an indispensable task in the thermal design of LED with multi-angle illumination function.
LED散热自然对流板状肋片散热器数值模拟倾角
LED coolingnatural convectionplate-fin heat sinknumerical simulationinclination angle
Cheng H C, Lin J Y, Chen W H. On the thermal characterization of an RGB LED-based white light module [J]. Appl. Therm. Eng., 2012, 38(5):105-116.
Narendran N, Gu Y, Freyssinier J P, et al. Solid-state lighting: Failure analysis of white LEDs [J]. J. Cryst. Growth, 2004, 268(3-4):449-456.
Fei X, Qian K Y, Luo Y. Junction temperature measurement and luminous properties research of high-power LED [J]. J. Optoelectron.Laser (光电子激光), 2008, 19(3):289-292 (in Chinese).
Tian C J, Zhang X Y, Zou J, et al. Temperature effect on the photoelectric parameter of high-power LED illumination system [J]. Chin. J. Lumin.(发光学报), 2010, 31(1):96-100 (in Chinese).
Wang L, Wu K, Yu Y B, et al. Study on LED array heat radiator improvement under natural convection [J]. J. Optoelectron.Laser (光电子激光), 2011, 22(3):338-342 (in Chinese).
Zhang J X, Niu P J, Wu Z G, et al. Two-objective optimization of heat sink cooling performance for high-power LED application [J]. Trans. China Electrotech. Soc.(电工技术学报), 2014, 29(4):136-141 (in Chinese).
Harahap F, Setio D. Correlations for heat dissipation and natural convection heat-transfer from horizontally-based, vertically- finned arrays [J]. Appl. Energy, 2001, 69(1):29-38.
Wang L, Wu K, Yu Y B, et al. Study on LED array heat transfer under natural convection based on CFD [J]. J. Optoelectron.Laser (光电子激光), 2010, 21(12):1758-1762 (in Chinese).
Shyu J C, Hsu K W, Yang K S, et al. Thermal characterization of shrouded plate fin array on an LED backlight panel [J]. Appl. Therm. Eng., 2011, 31(14-15):2909-2915.
Zhang J X, Niu P J, Li H Y, et al. Study on the heat dissipation performance of LED array using thermal circuit method [J]. Chin. J. Lumin.(发光学报), 2013, 34(4):516-522 (in Chinese).
Wang J C. Thermal module design and analysis of a 230 W LED illumination lamp under three incline angles. [J]. Microelectron. J., 2014, 45(4):416-423.
Shen Q, Sun D M, Xu Y, et al. Orientation effects on natural convection heat dissipation of rectangular fin heat sinks mounted on LEDs [J]. Int. J. Heat Mass Transf., 2014, 75(8):462-469.
Liu H L, Wu L G, Dai S X, et al. The analysis of irradiation angle impact on thermal performance of high-power LED downlight [J]. Chin. J. Electron Dev.(电子器件), 2013, 36(2):180-183 (in Chinese).
Davidzon M I. Newton's law of cooling and its interpretation [J]. Int. J. Heat Mass Transf., 2012, 55(21-22):5397-5402.
Shyu J C, Hsu K W, Yang K S, et al. Orientation effect on heat transfer of a shrouded LED backlight panel with a plate-fin array [J]. Int. Commun. Heat Mass Transf., 2013, 42:51-54.
Mittelman G, Dayan A, Dado-Turjeman K, et al. Laminar free convection underneath a downward facing inclined hot fin array [J]. Int. J. Heat Mass Transf., 2007, 50(13-14):2582-2589.
0
浏览量
51
下载量
4
CSCD
关联资源
相关文章
相关作者
相关机构