制备工艺对掺杂NaYF4:Er3+,Yb3+发光纳米晶的聚合物光波导放大器性能的影响

邢桂超; 黄雅莉; 张美玲; 王希斌; 王菲; 张大明

doi:10.3788/fgxb20183905.0681

您当前的位置：

首页 >

文章列表页 >

制备工艺对掺杂NaYF₄:Er³⁺,Yb³⁺发光纳米晶的聚合物光波导放大器性能的影响

器件制备及器件物理 | 更新时间：2020-08-12

- 制备工艺对掺杂NaYF₄:Er³⁺,Yb³⁺发光纳米晶的聚合物光波导放大器性能的影响
- Effect of Fabrication Technology of Polymer Optical Waveguide Amplifier Based on NaYF₄:Er³⁺,Yb³⁺ Nanocrystals on Device Performance
- 发光学报 2018年39卷第5期页码：681-686
- 作者机构：
  
  吉林大学电子科学与工程学院集成光电子学国家重点实验室, 吉林省光通信聚合物波导器件工程实验室, 吉林长春 130012
- 作者简介：
- 基金信息：
  
  国家自然科学基金（61475061，61575076，61405070）();吉林省省级产业创新专项资金（2016C019）资助项目()
- DOI：10.3788/fgxb20183905.0681
  中图分类号： O482.31
- 纸质出版日期：2018-5-5，
  
  网络出版日期：2018-1-5，
  
  收稿日期：2017-9-5，
  
  修回日期：2017-12-13，
扫描看全文
邢桂超, 黄雅莉, 张美玲等. 制备工艺对掺杂NaYF4:Er3+,Yb3+发光纳米晶的聚合物光波导放大器性能的影响[J]. 发光学报, 2018,39(5): 681-686

XING Gui-chao, HUANG Ya-li, ZHANG Mei-ling etc. Effect of Fabrication Technology of Polymer Optical Waveguide Amplifier Based on NaYF4:Er3+,Yb3+ Nanocrystals on Device Performance[J]. Chinese Journal of Luminescence, 2018,39(5): 681-686
邢桂超, 黄雅莉, 张美玲等. 制备工艺对掺杂NaYF4:Er3+,Yb3+发光纳米晶的聚合物光波导放大器性能的影响[J]. 发光学报, 2018,39(5): 681-686 DOI： 10.3788/fgxb20183905.0681.

XING Gui-chao, HUANG Ya-li, ZHANG Mei-ling etc. Effect of Fabrication Technology of Polymer Optical Waveguide Amplifier Based on NaYF4:Er3+,Yb3+ Nanocrystals on Device Performance[J]. Chinese Journal of Luminescence, 2018,39(5): 681-686 DOI： 10.3788/fgxb20183905.0681.

摘要

制备了NaYF

：Er

，Yb

纳米晶，表征了纳米晶的形貌，通过物理掺杂的方式将纳米粒子掺杂到SU-8中作为光波导放大器的芯层材料，优化了波导放大器的尺寸，利用旋涂、刻蚀等工艺，在二氧化硅衬底上制备了光波导放大器。实验中用光漂白法和湿法刻蚀两种方法制备光波导放大器，分别给出了两种方法制备的器件的结构、工艺流程、光场模拟结果，并对两种方法制备的器件的放大特性进行了测试。测试结果表明，当980 nm波长的泵浦光功率为241 mW且1 550 nm波长的信号光功率为0.1 mW时，使用湿法刻蚀法制备的放大器得到2.7 dB的相对增益。当980 nm波长的泵浦光功率为235 mW且1 550 nm波长的信号光功率为0.1 mW时，使用光漂白法制备的放大器得到4.5 dB的相对增益。根据以上测试结果，分析了两种工艺对器件性能的影响。

Abstract

NaYF

:Er

nanocrystals were synthesized and the morphology of nanocrystals was characterized. The nanocrystals were doped into SU-8 as the core material of the optical waveguide amplifier by physical doping method. The size of the waveguide amplifier was optimized. Polymer optical waveguide amplifiers were fabricated on a silica substrate by spin coating

photolithography and ICP etching. In the experiment

the optical waveguide amplifier was prepared by two methods:light bleaching and wet etching. The amplification characteristics of the devices prepared by the two methods are tested. The amplifier prepared using the wet etching method achieves a relative gain of 2.7 dB at 1 550 nm when the pump power is 241 mW and the signal light power is 0.1 mW. The amplifier prepared using the photobleaching method obtains a relative gain of 4.5 dB at 1 550 nm for 235 mW pump power and 0.1 mW signal power. Based on the above test results

the effects of the two processes on the device performance were analyzed.

关键词

波导放大器NaYF4:Er3+Yb3+纳米粒子聚合物

Keywords

optical waveguide amplifierNaYF4:Er3+Yb3+nanocrystalspolymer

references

DESURVIRE E, SIMPSON J R, BECKER P C. High-gain erbium-doped traveling-wave fiber amplifier[J]. Opt. Lett., 1987, 12(11):888-890.

KARVE G, BIHARI B, CHEN R T. Demonstration of optical gain at 1.06m in a neodymium-doped polyimide waveguide[J]. Appl. Phys. Lett., 2000, 77(9):1253-1255.

ZHANG D, CHEN C, CHEN C M, et al.. Optical gain at 1535 nm in LaF3:Er, Yb nanoparticle-doped organic-inorganic hybrid material waveguide[J]. Appl. Phys. Lett., 2007, 91(16):161109.

ZHAO P C, CHEN H Q, ZHENG C T, et al.. Gain and noise characteristics of phosphate glass Er3+-Yb3+ co-doped waveguide amplifiers[J]. Opt. Quant. Electron., 2014, 46(12):1571-1587.

ZHAO P C, ZHANG M L, WANG T J, et al.. Optical amplification at 1525 nm in BaYF5:20%Yb3+, 2%Er3+ nanocrystals doped SU-8 polymer waveguide[J]. J. Nanomater., 2014, 2014:153028-1-6.

尹姣. 基于铒镱共掺核壳纳米晶聚合物波导放大器[D]. 长春:吉林大学, 2016. YIN J. Polymer Waveguide Amplifiers Based on Er3+-Yb3+ Co-doped Core-shell Nanocrystals[D]. Changchun:Jilin University, 2016. (in Chinese)

CADA M, PITORA J. Design of a new terahertz nanowaveguide amplifier[J]. IEEE Photon. J., 2017, 9(3):2200905.

DEL HOYO J, MORENO-ZARATE P, ESCALANTE G, et al.. High-efficiency waveguide optical amplifiers and lasers via FS-laser induced local modification of the glass composition[J]. J. Lightw. Technol., 2017, 35(14):2955-2959.

TAN Y, SHANG Z, VANGA S K, et al.. High-gain optical waveguide amplifier based on proton beam writing of Nd:YAG crystal[J]. Opt. Express, 2015, 23(11):14612-14617.

MANRCONI J D, ABBADE M L F, SERPA-IMBETT C M, et al.. Ultra-broadband two-pump optical parametric amplifier in tellurite waveguides with engineered dispersion[J]. Opt. Express, 2017, 25(4):4268-4283.

尹姣, 曲春阳, 张美玲, 等. 基于铒镱共掺纳米晶的聚合物光波导放大器的增益特性[J]. 光学学报, 2015, 35(12):1213001. YIN J, QU C Y, ZHANG M L, et al.. Gain characteristics of polymer waveguide amplifiers based on Er3+, Yb3+ co-doped nanocrystals[J]. Acta Opt. Sinica, 2015, 35(12):1213001. (in Chinese).

MA L N, TAN Y, CHEN F. Optical amplifier based on an Er:MgO-doped near stoichiometric lithium niobate waveguide[J]. Opt. Mater., 2017, 69:115-118.

浏览量

101

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

纯有机室温磷光材料研究现状与策略

聚集诱导发光聚合物的机遇与挑战:聚合物之美与聚集体之光相辉映

红荧烯晶体薄膜的制备及应用研究进展

基于KMnF₃:Yb³⁺,Er³⁺纳米晶的红光聚合物平面光波导放大器

碳纳米管制备蓝光石墨烯量子点及其在柔性有机存储器上的应用