制备条件对含铜阳极氧化铝复合薄膜偏振特性的影响

董艳锋; 李清山; 田海峰; 吴福全

doi:null

您当前的位置：

首页 >

文章列表页 >

制备条件对含铜阳极氧化铝复合薄膜偏振特性的影响

论文 | 更新时间：2020-08-12

- 制备条件对含铜阳极氧化铝复合薄膜偏振特性的影响
- Effect of Preparation Conditions on Polarization Properties of Cu/PAA Films
- 发光学报 2009年30卷第2期页码：257-260
- 作者机构：
  
  1. 曲阜师范大学物理工程学院, 山东曲阜,273165
  2. 鲁东大学物理与电子工程学院,山东烟台,264025
  3. 曲阜师范大学激光研究所, 山东曲阜,273165
- 作者简介：
- 基金信息：
- DOI：
  中图分类号： O436.3;O484.4+1
- 收稿日期：2008-10-22，
  
  修回日期：1900-01-02，
  
  网络出版日期：2009-04-30，
  
  纸质出版日期：2009-04-30
- 稿件说明：
移动端阅览
董艳锋, 李清山, 田海峰, 等. 制备条件对含铜阳极氧化铝复合薄膜偏振特性的影响[J]. 发光学报, 2009,30(2):257-260.

DONG Yan-feng, LI Qing-shan, TIAN Hai-feng, et al. Effect of Preparation Conditions on Polarization Properties of Cu/PAA Films[J]. Chinese journal of luminescence, 2009, 30(2): 257-260.
董艳锋, 李清山, 田海峰, 等. 制备条件对含铜阳极氧化铝复合薄膜偏振特性的影响[J]. 发光学报, 2009,30(2):257-260. DOI：

DONG Yan-feng, LI Qing-shan, TIAN Hai-feng, et al. Effect of Preparation Conditions on Polarization Properties of Cu/PAA Films[J]. Chinese journal of luminescence, 2009, 30(2): 257-260. DOI：

摘要

利用多孔阳极氧化铝(PAA)的纳米列阵结构

将金属铜电镀到氧化铝的孔中

得到含有金属铜纳米列阵阳极氧化铝(Cu/PAA)膜。实验中发现

Cu/PAA膜的偏振特性与电镀条件有关。在一定的范围内

随着电镀时间和电流密度的增加

消光比增大。电镀溶液的温度也是影响Cu/PAA膜消光比的一个很重要的因素

在电镀溶液温度相对较高的情况下

电流密度相对较小时也可以获得相对较高的消光比。通过优化电镀条件可获得高效率的Cu/PAA膜微偏振器。这种电化学方法制备的微偏振器

制备工艺简单

尺寸可控

便于实现产业化

有广泛的应用前景。

Abstract

In recent years

there has been increasing interest in the fabrication of the ordered fine structure using the naturally occurring self-ordered structures because of their potential utilization in the development of micromechanical

electronic and optoelectronic devices. The porous anodic alumina (PAA) formed by electrochemical oxidation has a fine structure with a nanohole array

and the radius of the pores can be controlled in the range of 1.5 to 500 nm by changing the preparation conditions. The PAA has recently attracted increasing attention as a host by introducing a guest.In this paper

Cu was implanted into the pores of PAA by means of electroplating

and the Cu/PAA film was obtained. With such metallic array

the alumina films exhibit optical polarization properties. The experiment results indicated that the polarization properties of Cu/PAA film depend on electroplating conditions. To a certain extent

with the increase of electroplating time and current density

the extinction ratio of Cu/PAA film can be improved; the temperature of electroplating solution is an important factor to influence on the extinction ratio

because a higher extinction ratio can be obtained at a smaller density and a higher temperature. So

a micro-polarizer can be achieved by optimizing electroplating conditions. With the simple technique

the controlled size and the convenience for industrialization

the Cu/PAA film prepared by electrochemical oxidation has extensive prospects in optical telecommunication.

关键词

Keywords

references

. Keller F, Hunter M S, Robinson D L. Structural features of oxide coatings on aluminum [J]. J. Electrochem. Soc., 1953, 100 (9):411-419.

. Masuda H, Nisillo K, Baba N. Fabrication of porous TiO2 film using two-step replication of microstructure of anodic alumina [J]. Jpn. J. Appl. Phys. Part2, 1992, 31 (12B):L1775-L1777.

. Saito M, Kirihara M, Taniguchi T, et al. Micropolarizer made of the anodized alumina film [J]. Appl. Phys. Lett., 1989, 55 (7):607-609.

. Ai Hanhua, Wan Miao, Ren Lu, et al. Optical characteristic research of ZnS nanowire arrays prepared by porous anodic aluminum oxide template [J]. Chin. J. Lumin. (发光学报), 2005, 26 (5):631-634 (in Chinese).

. Saito M, Shibasaki M, Nakamura S, et al. Optical wave-guides fabricated in anodic alumina films [J]. Opt. Lett., 1994, 19 (10):710-712.

. Strijkers G J, Dalderop J H J, Broeksteeg M A A, et al. Structure and magnetization of arrays of electrodeposited Co wires in anodic alumina [J]. J. Appl. Phys., 1999, 86 (9):5141-5145.

. Yang Shaoguang, Zhu Hao, Yu Dongliang, et al. Preparation and magnetic property of Fe nanowire array [J]. J. Mag. Mag. Mater., 2000, 222 (1-2):97-100.

. Shi Mingji, Li Qingshan, Zhang Ning, et al. Structural and optical properties of ZnO films deposited on porous anodic alumina substrates by pulsed laser deposition [J]. Chin J. Lumin. (发光学报), 2006, 27 (6):981-986 (in Chinese).

. Li Hongliang, Zhai Jiang, Wan Yong, et al. Preparation of the oxidized porous silicon with stable surface composition and intense photoluminescence [J]. Chin. J. Lumin. (发光学报), 2008, 29 (5):879-884 (in Chinese).

. Masuda H, Saton M. Fabrication of gold nanodot array using anodic porous alumina as an evaporation mask [J]. Jpn. J. Appl. Phys. Part 2, 1996, 35 (1B):L26-L29.

. Dong Yanfeng, Li Qingshan, Wu Fuquan, et al. Polarization properties of anodic alumina with copper metallic columnas [J]. J. Optoelectronics·Laser (光电子·激光), 2002, 13 (11):1113-1115 (in Chinese).

. Nakamura S, Saito M, Huang Lifeng, et al. Infrared optical constants of anodic alumina films with micropore arrays [J]. Jpn. J. Appl. Phys. Part 1, 1992, 31 (11):3589-3593.

. Baba K, Shiraishi K, Obi K, et al. Optical properties of very thin metal films for laminated polarizers [J]. Appl. Opt., 1988, 27 (12):2554-2560.

. Jia Memgqiu, Yang Wensheng. Applied Electrochemistry [M]. Beijing: High Education Press, 2004, 239-240(in Chinese).

浏览量

132

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

含分枝铜纳米线多孔铝膜的偏振特性