夏季温室环境下植物生长用LED灯具散热结构的温度分布模型构建与验证

吕北轩; 陈豫仁; 熊峰

doi:10.3788/fgxb20183908.1115

您当前的位置：

首页 >

文章列表页 >

夏季温室环境下植物生长用LED灯具散热结构的温度分布模型构建与验证

器件制备及器件物理 | 更新时间：2020-08-12

- 夏季温室环境下植物生长用LED灯具散热结构的温度分布模型构建与验证
- Mathematical Calculation Model and Its Verification for Temperature Distribution of LED Lighting's Heatsinks for Plant Growth in The Summer Greenhouse
- 发光学报 2018年39卷第8期页码：1115-1122
- 作者机构：
  
  1. 上海大学机电工程与自动化学院上海市智能制造及机器人重点实验室, 上海 200072
  2. 上海大学材料科学与工程学院电子信息材料系, 上海 200072
- 作者简介：
- 基金信息：
- DOI：10.3788/fgxb20183908.1115
  中图分类号： TN312.8
- 纸质出版日期：2018-8-5，
  
  网络出版日期：2018-4-10，
  
  收稿日期：2017-12-5，
  
  修回日期：2018-3-24，
扫描看全文
吕北轩, 陈豫仁, 熊峰. 夏季温室环境下植物生长用LED灯具散热结构的温度分布模型构建与验证[J]. 发光学报, 2018,39(8): 1115-1122

LYU Bei-xuan, CHEN Yu-ren, XIONG Feng. Mathematical Calculation Model and Its Verification for Temperature Distribution of LED Lighting's Heatsinks for Plant Growth in The Summer Greenhouse[J]. Chinese Journal of Luminescence, 2018,39(8): 1115-1122
吕北轩, 陈豫仁, 熊峰. 夏季温室环境下植物生长用LED灯具散热结构的温度分布模型构建与验证[J]. 发光学报, 2018,39(8): 1115-1122 DOI： 10.3788/fgxb20183908.1115.

LYU Bei-xuan, CHEN Yu-ren, XIONG Feng. Mathematical Calculation Model and Its Verification for Temperature Distribution of LED Lighting's Heatsinks for Plant Growth in The Summer Greenhouse[J]. Chinese Journal of Luminescence, 2018,39(8): 1115-1122 DOI： 10.3788/fgxb20183908.1115.

摘要

以热传导流入肋片热量与通过空气与肋片间的对流所散出的热量及湿空气凝结所需热量之和相等作为条件，构建了可以实际反映温室环境影响下的植物生长用LED灯具散热结构的温度分布模型。通过实验结合仿真模拟，实现对温室环境的物理仿真模型的建立，并以模型得到了灯具处于最为恶劣的工况下的空气物理参数。结合具体的空气物理参数以及所构建的数学模型，计算出了悬挂在温室中部2.5 m高度处的150 W植物生长用LED灯具在最为恶劣的工况下的散热结构关键节点的温度数值，并运用红外热像仪，对关键温度节点进行了收集。数据表明，计算值与实验值及仿真值的数值误差均不超过5%，验证了模型的正确性，对具体的植物生长用LED灯具的散热结构的设计具有积极的指导作用。

Abstract

A mathematic model of LED heatsinks in greenhouses was established by the condition that the heat conducted into the fin heat equals the total heat from the air convection and the condensation of wet air. The air physical parameters under the worst condition were obtained by the physical simulation model of the greenhouse environment established by experiment and simulation. After obtaining the specific air physical parameters

combined with the constructed mathematical model

the temperature values of the key nodes of a 150 W plant growth LED lamp's heatsink suspended at the height of 2.5 m in the middle of the greenhouse were calculated in the worst case. The correctness of the model was verified by experiment and simulation

the data show that the relative error is not more than 5%

thus this has a positive effect for the design of LED lamps' heatsink for greenhouse.

关键词

LED散热光学器件温度分布数学模型温室环境数值仿真

Keywords

LED heat dissipationoptical devicemathematical model of temperature distributiongreenhouse environmentnumerical simulation

references

SCHUBERT E F, KIM JK. Solid-state light sources getting smart[J]. Science, 2005, 308(5726):1274-1278.

KWAG D S, SO S H, BAEK S M. Study on thermal and structural stability of high power light-emitting diode lighting system[J]. J. Nanosci. Nanotechnol., 2014, 14(5):3564-3568.

朱舟, 应盛盛, 胡洪钧, 等. LED植物光源阵列光照分布及均匀性研究[J]. 浙江农业学报, 2015, 27(8):1489-1493. ZHU Z, YING S S, HU H J, et al.. Study on illumination distribution and uniformity for LED plant light source array[J]. Acta Agricult. Zhejiangensis, 2015, 27(8):1489-1493. (in Chinese)

刘彤, 刘雯, 马建设. 可调红蓝光子比例的LED植物光源配光设计方法[J]. 农业工程学报, 2014, 30(1):154-159. LIU T, LIU W, MA J S, et al.. Distribution design method for LED plant light source with tunable ratio of red/blue photons[J]. Trans. Chin. Soc.Agricult. Eng., 2014, 30(1):154-159. (in Chinese)

徐秀知, 王淑凡, 王巍, 等. 全数字智能LED植物补光灯控制系统[J]. 天津工业大学学报, 2012, 31(4):57-60. XU X Z, WANG S F, WANG W, et al.. All-digital intelligent control system of LED plant light supplement lamp[J]. J. Tianjin Polytech. Univ., 2012, 31(4):57-60. (in Chinese)

刘晓英, 焦学磊, 要旭阳, 等. 水冷式植物工厂LED面光源及散热系统的研制与测试[J]. 农业工程学报, 2015, 31(17):244-247. LIU X Y, JIAO X L, YAO X Y, et al.. Design and test of LED surface light source used in plant factory with water-cooling system[J]. Trans. Chin. Soc.Agricult. Eng., 2015, 31(17):244-247. (in Chinese)

陈杰. 室内照明用LED灯具散热建模仿真及散热优化设计应用研究[D]. 厦门:厦门大学, 2014:9-10. CHEN J. Thermal Modeling Simulation and Application Research on Thermal Optimization Design of Indoor Lighting LED Lamps[D]. Xiamen:Xiamen University, 2014:9-10. (in Chinese)

YU S H, LEE K S, YOOK S J. Optimum design of a radial heat sink under natural convection[J]. Int. J. Heat Mass Transfer, 2011, 54(11):2499-2505.

MIN W J, JEON S W, KIM Y. Optimal thermal design of a horizontal fin heat sink with a modified-opening model mounted on an LED module[J]. Appl. Therm. Eng., 2015, 91:105-115.

SUN L, ZHU J, WONG H. Simulation and evaluation of the peak temperature in LED light bulb heatsink[J]. Microelectron. Reliab., 2015, 61:140-144.

张建新, 牛萍娟, 李红月, 等. 基于等效热路法的LED阵列散热性能研究[J]. 发光学报, 2013, 34(4):516-522. ZHANG J X, NIU P J, LI H Y, et al.. Study on the heat dissipation performance of LED array using thermal circuit method[J]. Chin. J. Lumin., 2013, 34(4):516-522. (in Chinese)

孔亚楠. 大功率LED结温预测模型的研究[D]. 秦皇岛:燕山大学, 2015:13-56. KONG Y N. Study on Prediction Model of High Power LED's Junction Temperature[D]. Qinhuangdao:Yanshan University, 2015:13-56. (in Chinese)

王忠锋, 黄伟玲, 白金强. 大功率LED灯具散热的优化设计[J]. 照明工程学报, 2014, 25(3):84-88. WANG Z F, HUANG W L, BAI J Q. Heat dissipation optimal design for high power LED luminaire[J]. China Illumin.Eng. J., 2014, 25(3):84-88. (in Chinese)

SHARQAWY M H, ZUBAIR S M. Efficiency and optimization of a straight rectangular fin with combined heat and mass transfer[J]. Heat Transfer Eng., 2008, 29(12):1018-1026.

KUEHN T H, RAMSEY J W, THRELKELD J L. Thermal Environmental Engineering[M]. Upper Saddle River:Prentice-Hall Inc., 1998:243-261.

杨世铭, 陶文铨. 传热学[M]. 北京:高等教育出版社, 1998:183-186. YANG S M, TAO W Q. Heat Transfer[M]. Beijing:Higher Education Press, 1998:183-186. (in Chinese)

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

基于PWM调光的高显色性白光LED混光优化方法

电流拥挤效应与LED器件可靠性分析

纳米ZnO薄膜对有机电致发光器件性能的影响