碳酸铯修饰Al作为反射阴极的倒置顶发射OLED器件

张浩; 王立; 容佳玲; 曹进; 张志林; 蒋雪茵; 张建华

doi:10.3788/fgxb20123306.0611

您当前的位置：

首页 >

文章列表页 >

碳酸铯修饰Al作为反射阴极的倒置顶发射OLED器件

器件制备及器件物理 | 更新时间：2020-08-12

- 碳酸铯修饰Al作为反射阴极的倒置顶发射OLED器件
- Efficient Inverted Top-emitting Organic Light-emitting Devices with Cesium Carbonate Modified Al Cathode
- 发光学报 2012年33卷第6期页码：611-615
- 作者机构：
  
  1. 上海大学新型显示技术与应用集成教育部重点实验室上海,200072
  2. 上海大学机电工程与自动化学院上海,200072
  3. 上海大学材料学院上海,200072
- 作者简介：
- 基金信息：
  
  上海市科委(09ZR1411900)();国家863计划(2010AA03A337)资助项目()
- DOI：10.3788/fgxb20123306.0611
  中图分类号： TN383+.1
- 纸质出版日期：2012-6-10，
  
  网络出版日期：2012-6-10，
  
  收稿日期：2012-3-9，
  
  修回日期：2012-4-23，
扫描看全文
张浩, 王立, 容佳玲, 曹进, 张志林, 蒋雪茵, 张建华. 碳酸铯修饰Al作为反射阴极的倒置顶发射OLED器件[J]. 发光学报, 2012,(6): 611-615

ZHANG Hao, WANG Li, RONG Jia-Ling, CAO Jin, ZHANG Zhi-Lin, JIANG Xue-Yin, ZHANG Jian-Hua. Efficient Inverted Top-emitting Organic Light-emitting Devices with Cesium Carbonate Modified Al Cathode[J]. Chinese Journal of Luminescence, 2012,(6): 611-615
张浩, 王立, 容佳玲, 曹进, 张志林, 蒋雪茵, 张建华. 碳酸铯修饰Al作为反射阴极的倒置顶发射OLED器件[J]. 发光学报, 2012,(6): 611-615 DOI： 10.3788/fgxb20123306.0611.

ZHANG Hao, WANG Li, RONG Jia-Ling, CAO Jin, ZHANG Zhi-Lin, JIANG Xue-Yin, ZHANG Jian-Hua. Efficient Inverted Top-emitting Organic Light-emitting Devices with Cesium Carbonate Modified Al Cathode[J]. Chinese Journal of Luminescence, 2012,(6): 611-615 DOI： 10.3788/fgxb20123306.0611.

摘要

以Cs

修饰的Al电极作为反射阴极制备了高效倒置顶发射结构有机电致发光器件(ITOLED)。以八羟基喹啉铝(Alq

)作为发光层、MoO

修饰的Ag为半透明阳极时

器件的开启电压为3.6 V

发光效率和功率效率分别达到9.8 cd/A和3.4 lm/W。研究结果表明

Al/Cs

为反射阴极的器件性能明显高于使用Mg:Ag(4.2 V

8.6 cd/A

2.85 lm/W)和Al(5 V

5.5 cd/A

1.57 lm/W)作为反射阴极的倒置顶发射OLED器件。单电子器件研究结果证明

以Cs

修饰的Al电极功函数明显低于Mg:Ag和Al电极

具有更好的电子注入效果。因此

除去微腔效应外

Al/Cs

为反射电极的ITOLED器件性能的提高主要归因于Al/Cs

阴极的有效电子注入。

Abstract

Efficient inverted top-emitting organic light-emitting diode(ITOLED) using a thin Cs

layer modified Al as the reflective bottom cathode is demonstrated. With tris-(8-hydroxy-quinoline) aluminum (Alq

) as emitting layer and MoO

/Ag as semitransparent anode

the Al/Cs

based ITOLED shows a tune-on voltage of 3.6 V

luminance efficiency of 9.8 cd/A and 3.4 lm/W

which are much better than those (4.2 V

8.6 cd/A

2.85 lm/W) obtained from Mg:Ag based ITOLED and those (5 V

5.5 cd/A

1.57 lm/W) obtained from bare Al based ITOLED. Electron-only devices research shows that a stronger electron-injection is obtained from Al/Cs

than Mg:Ag and Al

which is attributed to the lower work function of Al/Cs

than Mg:Ag and Al. The good performance of Al/Cs

based ITOLED is attributed to the efficient electron injection from the Al/Cs

cathode as well as a microcavity effect.

关键词

有机电致发光Cs2CO3倒置顶发射电子注入

Keywords

OLEDCs2CO3inverted top-emittingelectron injection

references

Tang C W, Van Slyke S. Organic electroluminescent diodes [J]. Appl. Phys. Lett., 1987, 51(9):913-915.[2] Chen S Y, Chu T Y, Chen J F, et al. Stable inverted bottom-emitting organic electroluminescent devices with molecular doping and morphology improvement [J]. Appl. Phys. Lett., 2006, 89(5):053518-1-3.[3] Lee Y, Kim J, Kwon S, et al. Interface studies of aluminum,8-hydroxyquinolatolithium (Liq) and Alq3 for inverted OLED application [J]. Org. Electron., 2008, 9(3):407-412.[4] Meyer J, Winkler T, Hamwi S, et al. Transparent inverted organic light-emitting diodes with a tungsten oxide buffer layer [J]. Adv. Mater., 2008, 20(20):3839-3843.[5] Wang Q, Deng Z Q, Chen J S, et al. Manipulating the microcavity structure for highly efficient inverted top-emitting organic light-emitting diodes:Simulation and experiment [J]. IEEE Trans. Electron Devices, 2010, 57(9):2221-2226.[6] Wang Z K, Lou Y H, Naka S, et al. High efficiency rubrene based inverted top-emission organic light emitting devices with a mixed single layer [J]. J. Lumin., 2010, 130(7):1198-1202.[7] Li Y, Zhang D Q, Duan L, et al. Elucidation of the electron injection mechanism of evaporated cesium carbonate cathode interlayer for organic light-emitting diodes [J]. Appl. Phys. Lett., 2007, 90(1):012119-1-3.[8] Chen M H, Wu C I. The roles of thermally evaporated cesium carbonate to enhance the electron injection in organic light emitting devices [J]. J. Appl. Phys., 2008, 104(11):113713-1-3.[9] Huang J, Xu Z, Yang Y. Low-work-function surface formed by solution-processed and thermally deposited nanoscale layers of cesium carbonate [J]. Adv. Funct. Mater., 2007, 17(12):1966-1973.[10] Wu C I, Lin C T, Chen Y H. Electronic structures and electron-injection mechanisms of cesium-carbonate-incorporated cathode structures for organic light-emitting devices [J]. Appl. Phys. Lett., 2006, 88(15):152104-1-3.[11] Liu Aihua, Yang Liying. Improved performance of organic light emitting diodes using combined hole-injecting layer [J]. Chin. J. Lumin.(发光学报), 2012, 33(4):422-427 (in Chinese).[12] Lin Wenjing, Su Wenming, Zhang Dongyu, et al. Properties improvement of polymer white organic light emitting devices by phosphorescence sensitizer [J]. Chin. J. Lumin.(发光学报), 2012, 33(4):440-443 (in Chinese).[13] Cai Y, Wei H X, Li J, et al. Mechanism of Cs2CO3 as an n-type dopant in organic electron-transport film [J]. Appl. Phys. Lett., 2011, 98(11):113304-1-3.[14] Cho H, Choi J M, Yoo S. Highly transparent organic light-emitting diodes with a metallic top electrode:The dual role of a Cs2CO3 layer [J]. Opt. Express, 2011, 19(2):1113-1121.[15] Lian J R, Liu Y W, Niu F F, et al. Improved electron injection of OLEDs with a thin PBD layer at Alq3/Cs2CO3 interface [J]. Appl. Surf. Sci., 2011, 257(10):4608-4611.[16] Lin C L, Lin H W, Wu C C. Examining microcavity organic light-emitting devices having two metal mirrors [J]. Appl. Phys. Lett., 2005, 87(2):021101-1-3.[17] Lee C J, Pode R B, Moon D G, et al. On the problem of microcavity effects on the top emitting OLED with semitransparent metal cathode [J]. Phys. Stat. Sol.(a), 2004, 201(5):1022-1028.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

发光自由基老树发新芽

BPhen作为发光层间隔层对黄光OLED的影响

钙铝镁合金阴极对WOLED器件性能的影响

基于新型连接层的有机叠层电致发光器件

Cs₂CO₃共蒸阴极对有机电致发光器件性能的影响