浏览全部资源
扫码关注微信
1. 中国科学技术大学物理系, 安徽, 合肥, 230026
2. 中国科学院结构分析重点实验室, 安徽, 合肥, 230026
3. 中国科学技术大学精密机械与精密仪器系, 安徽, 合肥, 230027
收稿日期:2002-08-14,
修回日期:2002-10-25,
纸质出版日期:2003-03-20
移动端阅览
许小亮, 徐军, 徐传明, 杨晓杰, 郭常新, 施朝淑. Si表面上生长的ZnO薄膜的阴极射线荧光[J]. 发光学报, 2003,24(2): 171-176
XU Xiao-liang, XU Jun, XU Chuan-ming, YANG Xiao-jie, GUO Chang-xin, SHI Chao-shu. Cathodoluminescence of ZnO Films on Silicon[J]. Chinese Journal of Luminescence, 2003,24(2): 171-176
几种不同温度下退火的用直流溅射法生长的ZnO/Si样品的阴极射线荧光(CL)光谱显示
当退火温度低于等于800℃时
随着退火温度的升高
薄膜的晶体质量得到了改善
这主要体现在390nm紫外带的发射强度与505nm绿带发射强度的相对比值迅速增加
同时也发生了绿带的红移以及窄化效应。但退火温度超过800℃时绿带就不再红移了
其峰位为525nm。当退火温度为950℃时
紫外带几乎消失
而只剩下绿带
且与纯硅酸锌样品的CL谱一致
掠入射X射线衍射测量表明
确有三角相三元化合物硅酸锌的产生。因此
从ZnO/Si异质结的质量来看
直流溅射法可能不适宜用于生长这样的异质结:因为当退火温度低于800℃且相差较大(如600℃)时
不能得到产生强ZnO紫外发光的晶体质量
而当退火温度接近或高于800℃时
虽然ZnO晶体质量得到了改善从而紫外发光份额迅速增加
但同时也产生了新的三元化合物硅酸锌
将严重影响ZnO/Si异质结的电学输运特性。
Among several methods to grow the ZnO film
the DC sputtering (DCS) by using sil icon or silicate substrate appears easier in growth and with lower cost. However
the later needs high temperature (800~1000℃) treatment in order to obtain the film with a qualified orientation. It is then the motivation in our research to study the annealing effect on the structure and the luminescent characterization of the ZnO films. In our previous work
the X-ray diffraction with glancing input angle (GXRD) was measured on as-grown and annealed samples
which indicated a triangular compound zinc silicate appeared while the temperature higher then 800℃. In this work
the cathodoluminescence (CL) spectra of a ZnO film on Si
a nnealed at different temperature
were measured. The results showed that
the crystal quality of the film improved with increasing the annealing temperature
while the hexagonal phase of the ZnO film transformed into a kind of mixture phase including a hexagonal and a trigonal phase
after annealing at the temperature lower then 800℃ for one hour. The CL spectrum also shows the intrinsic emission bands of ZnO (two emission bands at 390nm UV band and 505nm green band) and Zn
2
SiO
4
(just one emission band at 525nm)
in which the ZnO is the main source of the spectrum (this is indicated by the red shift of the green band from 505nm to the 525nm band
and the width of the green band was narrowed
as increasing the annealing temperature). Increasing the temperature continuously up to 950℃ changed the main source of sample’s luminescence from the emission of ZnO to the emission of zinc silicate (the red shift stopped at the 525nm). This indicates acreation of new ternary compound Zn
2
SiO
4
in the film. In conclusion
in order to obtain a qualified crystalline ZnO films on silicon or silicate glass grown by DCS method
it is necessary to use heat treatment with high temperature. Although the crystalinity of the film was improved along with increasing the annealing temperature
however
a new ternary compound Zn
2
SiO
4
with triangular structure was found in the films annealed at the temperature higher than 770℃. Therefore
we have to face to such perplex if we decide to choose the DCS or other methods which needs a high temperature treatment to grow ZnO film on silicon
although such methods may have fairly simple techniques and are cheap in cost.
0
浏览量
88
下载量
6
CSCD
关联资源
相关文章
相关作者
相关机构